pokiesclub.club.

Hook Up Speakers And Sub To Amp: Roommate Hookup!

Up Sub And Hook Amp Speakers To

Connect bookshelf speakers to computer - Step by step

29 Jul Setting this up merely requires connecting the LFE (or subwoofer output) jack on the receiver/amplifier to the 'Line In' or 'LFE In' jack on the subwoofer. If the subwoofer has two sets of spring clips (for speaker in and speaker out), then it means that other speakers connect to the subwoofer, which then. New to this forum, hope this is the proper place to post for advice on this topic. I have a Ekho 2 channel amplifier which I have my 2 speakers plugged into as binding post. I want to connect a subwoofer I want to order too. The Ekho amplifier has speakon output too with left, right and a middle input for it. I have a Dual XPE Watt 2-channel amplifier, and am currently running two 6x9 polk audio watt rms and watt max speakers.. As of now I've not looked up the specifications for the amp you mentioned, just remember to keep the speaker resistance above the capabilities of the amp. Aug

How do you connect a subwoofer to an amplifier?

Subwoofers are used in most home theater systems, but subs can also radically improve the sound of stereo systems -- and not just the ones with small speakers. Subs can provide a foundation to the sound that few speakers can muster on their own.

How to: Install a Subwoofer and Amplifier in a car - Hook Up With Ex!

So adding a sub is not just about adding more and deeper bass; rather, a properly integrated subwoofer can improve the overall sound of the system. Subwoofer connection to a two-channel system differs from the methods used in home theaters.

Share your voice

AV receivers feature bass management to direct the low bass frequencies to the sub and the midrange and treble frequencies to the speakers. The subwoofer is hooked up to the receiver with a single interconnect cable. Stereo receivers, pre-amps, and integrated amplifiers rarely have subwoofer output jacks or offer bass-management options.

Hook Up Speakers And Sub To Amp

So instead of using those connections, we'll use the subwoofer's speaker-level, aka "high-level," inputs. Most, but not all, subwoofers have these inputs; they get connected using speaker cables to the same speaker output jacks on your receiver or amplifier that are also hooked up to your speakers.

That means you have to double up the connections on the receiver or amplifier see photo below that illustrates that connection method. With this arrangement, the stereo speakers and sub receive all of the bass, midrange, and treble frequencies.

Then set the sub's volume control to provide the level of bass support you want. You want to ground your cap. Remove the wire and find the correct remote amp, then turn on wire or ignition wire to the vehicle.

The sub will use its built-in crossover aka "low pass" filter to determine the upper limit of the frequencies produced by the subwoofer. With small speakers with 4-inch or smaller woofers, you'll set the sub's crossover frequency at Hz or higher, and with speakers with 5-inch or larger woofers, 80Hz or lower.

Then set the sub's volume control to provide the level of bass support you want. I like to bring the sub's volume up to the point where I just start to hear the bass filling out the speakers' sound, but some listeners prefer more pronounced bass fullness.

Hook Up Speakers And Sub To Amp

I usually spend at least a few hours listening with lots of different types of music to fine-tune the crossover and subwoofer volume settings. For more information read this post on how to set up a subwoofer.

This story was originally published on April 15,and has since been updated with additional information. Be respectful, keep it clean and stay on topic. We'll remove comments that violate our policy. Please read our Comment Policy before commenting. Don't show this again. Home Entertainment How to hook up a subwoofer to a stereo system Hint: You don't necessarily need a receiver with subwoofer output jacks.

Sign in to comment Be respectful, keep it clean and stay on topic. Cryptocurrency like bitcoin is easy money for criminals.

The remote wire tells the amp to turn on. My amp is putting power to my speakers and subs. Do I need to fuse the main amp power to the battery?